Blog

In the bridge rectifier bellow at first we increase C1’s value then we increase R1 value. Choose the correct answer.

Which of the following statements are correct: A. The electrical power that we get from the wall outlets is 120V AC(volts, alternating current).  B. The bridge rectifier is the first step in AC to DC conversion. C. A bridge rectifier is an arrangement of four diodes to convert a bipolar AC waveform into a unipolar waveform. D. One way to help regulate the output (AC to DC conversion) is to add a filter capacitor to the output. The larger the capacitor, the more energy it can store, further reducing the ripple effect.

What is the general function of this circuit?

An ac power module connected to a power outlet in Bangladesh is supplying to a Bridge rectifier circuit (lab 8 setup). The output of the rectifier has a frequency of 100Hz. What is the power line frequency (in Hz) in Bangladesh?

The figure below shows a first-order active low pass filter.   You are given that C = 33nF and RB = 2kΩ. (a) For a cutoff frequency of 2000 Hz, what value of R should you choose? (Answer to the nearest ohm)

The following schematic is a linear power supply circuit. If the measured peak-to-peak voltage from node A is , calculate the Vrms of this node. Express your answer in volts (rms).

For the circuit shown below, Vin1 is a 2 Vpp sine wave with frequency 1 kHz. Vin2 is a 3 Vpp sine wave with frequency 1 kHz. Vin1 and Vin2 are exactly in phase with each other. What would be the observed peak to peak (Vpp) value of Vout? Express your answer in volts, peak to peak (Vpp).     

In the peak-hold circuit, select all the following ways to find the time constant.

Name the circuit shown below  

A first-order passive low pass filter usually has one end of the resistor connected to a function generator, and the other end connected to a capacitor to ground. If another capacitor of the same value as the first capacitor is connected across the first capacitor, how will the cutoff frequency be affected?